❏
2. Turn the fuselage over and cut away the
covering on the bottom of the fuselage for the
landing gear.
❏
3. Cut away the covering at the wing saddle for
the wing hold down dowel holes.
❏
4. Using 6-minute epoxy, glue the two wooden
dowels in place at the wing saddle.
❏
5. Fit the horizontal stabilizer in place at the
rear of the fuselage. Do not glue it in place!
❏
6. Apply a piece of masking tape across the top
of the fuselage at the back of the wing saddle.
Mark the center of the fuselage on the tape. Insert
a T-pin on the center mark.
❏
7. Attach one end of monofilament string or a
small tape measure to the T-pin. Measure back to
the end of the stabilizer on the left side of the
fuselage. Do the same for the right side of the
fuselage. When the distance from the T-pin to each
side of the stabilizer is equal, the stab is properly
positioned.
8
