❏
1. Unscrew the
fin mounting nuts
from the fin
mounting rods.
❏
2. Holding the parts in your hands, connect the
pushrods to the middle hole in the control horns on the
elevator and rudder. (You can get a closer look in the
bottom, two photos on this page.)
❏
3. Join the fin and stabilizer to the fuselage by
inserting the threaded rods down through the stabilizer
and the fuselage.
Note:
Use care not to push the rods
through the wire receiver antenna inside the fuselage.
This is how the pushrods should look when connected
to the control horns on the elevator and rudder.
ASSEMBLY
FLYZONE 3-CHANNEL FM
TRANSMITTER (TX)
5
