The SpeedBrakes Training Flaps were designed to allow your
NexSTAR Select to fly slower, reduce top speed and shorten
the landing approach. Thanks to these flaps, your NexSTAR
Select will bleed off speed quickly when the throttle is
reduced so that long landing approaches are not necessary.
Additionally, the top speed is considerably reduced to make
the airplane easier to handle. These SpeedBrakes can also
be removed after acquiring some experience with the
airplane for faster, more aerobatic performance.
The wings of most trainers are mounted with rubber bands.
This allows for some flexibility in case of a hard landing.
Rubber bands work well, but they are just plain ugly and a
mess. The PivotFlex Wing Mounting System combines the
looks of a bolt-on system with the flexibility of rubber bands.
The new system allows the wing to move under sudden
loads (such as a wing tip hitting the ground) and will release
the wing from the airplane under extreme loads such as a
crash—all that while looking great.
The EasyAlign Tail Mounting System aligns the stabilizer
with the fuselage and fin while tightening the tail bolts. The
tail bolts slide into blocks in the fuselage under the
stabilizer. As the tail bolts are tightened, both the fin and
stab are aligned and secured while strengthening the aft
area of the fuselage. No tools are necessary for installation.
To speed and simplify assembly, the Hobbico NexSTAR
Select comes equipped with the SnapGear Landing Gear.
This new gear offers effortless and tool less main landing
gear installation. It takes only a few seconds to install the
landing gear and it can also be removed from the fuselage
in seconds.
SnapGear
™
Landing Gear
EasyAlign
™
Tail Mounting System
PivotFlex
™
Wing Mounting System
SpeedBrakes
™
Training Flaps
5
Summary of Contents for Nexstar select
Page 28: ...28 Correct Angle Rods Fin ...