If the quadcopter is constantly drifting in the same direction or a new flight control board has been installed, the sensors on the Ominus should be calibrated.
1. Center all the trim adjustments. To check the trim, push the trim button once on one side and then once on the opposite side. When the trim is centered,
the transmitter will emit a long, low pitched beep. The transmitter will emit a short beep of lower pitch as the adjustment gets closer to center and higher
pitch as the adjustment moves away from center. Continue pressing the trim button that has the lower pitch until the adjustment is centered.
2. Push down on the right stick and hold it. The radio will steadily beep while the stick is held down.
3. Press down on the left stick 3 times within 2 seconds. The radio will stop the steady beep and make a short beep when the stick is pressed the third time.
4. Release both sticks and push up on the throttle trim button. The red LED will flash slowly and become steady again when the calibration is complete.
5. Press down on the left stick to save the settings.
QUADCOPTER SENSOR CALIBRATION
6. Turn on the controller and plug in the battery for the Ominus FPV.
7. Go to the Wi-Fi setting on your phone and check that the FPVCAM is
on. The password for the FPV Cam is 1234567890.
8. Open the FPVCAM app on your phone and push the “+” in the upper
right hand corner. This will locate the camera.
9. Once the device finds the camera, push the
button. The FPV
camera should be displaying at this point.
1. Install the “FPVCAM” app from Google Play (Android
®
) or the App Store (Apple
®
).
5. Install the Light shield if desired.
Onboard camera is not to be used for commercial ventures. Be sure to fly in a safe environment and respect
the privacy of others. Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other
countries. App Store is a service mark of Apple Inc. Android
™
and Google Play are trademarks of Google Inc.
FIRST PERSON VIEW (FPV) SETUP
2. Remove the protective film
from the camera lens.
protective film
REMO
VE
3. Insert the memory card into
the camera on the quad.
INSER
T
4.
Install the phone mount onto the controller. For optimal
performance, please keep the controller’s antenna at least 7"
(18cm) away from smartphones. Failure to do so may result in
unwanted interference which can cause pilots to lose control of
their model and/or experience poor video reception. Do not alter
the smartphone holder in any way.
