WING ASSEMBLY
3 Trial fit the 7mm dowel rods into the holes and butt them up
against the front spar They should be positioned straight in and
parallel to the wing root Once satisfied with the fit, epoxy them
in place using slow cure epoxy.
1. On both wing halves, make a mark exactly 1 from the wing root
on the leading edge
4. Next, using a sanding block sand the wing roots of both w i n g
halves to ensure that they are perfectly flat Be careful not to
change the dihedral angle of the root
2 Drill a 7mm hole at each mark Make sure that you drill straight
in at the center of the mark parallel to the wing root
5 Trim each wing half for the aileron servo as shown It's much
easier to do this now than after the wing is assembled
4.
