Install (1) M3-4 Pivot Ball Stud to (1)
Tail Pitch Control Lever.
Install Completed tail Pitch Slider onto
the tail output shaft.
Install Tail Pitch Control Lever using (1)
M3-5-1 spacer, (1) M3-16 Cap Head
Bolt, and (1) M3 Locknut. Couple the
pivot ball from the tail pitch slide in the
brass cup from tail pitch control lever
and attach the lever using the above
hardware with the spacer between the
lever and the mount.
Note:
Be sure not to over tighten the
bolt for the tail pitch lever. Use the
supplied nut to lock the bolt in place.
The lever should rotate freely.
