[31]
□
Step 12: Secure AC Wiring
– secure the wire bundle to the power supply plate with four cable ties.
Make
sure that the locking clip is on the wire side on the plate NOT below the plate or the two plates will not fit
together.
The DC terminals on the Meanwell power supplies have a square washer to ensure good contact with the spade
terminals on the DC power cables. Be certain that these washers are on top of the terminals (not underneath) and
aligned with the terminal, not diagonal.
The negative terminal is closest to the power LED and the voltage adjustment pot, as shown here:
□
Step 13: Power Board Terminal Blocks
– Loosen the screws in the terminal blocks on the power board by
turning the screws CCW units you hear a click.
□
Step 14: DC Wiring
– Locate the three power supply to power board wires, they are red/black zip cord and
have blue spade terminals on one end and tinned, bare wire on the other. They are 4, 6 and 9 inches in length.