[37]
□
Step 6: SO239 Mounting –
Place the three SO239 jacks over the jack screws with the center pins projecting
through the PCB then place the rear panel over the SO239 jacks.
□
Step 7: SO239 screws –
Use the thirteen #4-40 X ¼” screws to fasten the SO239 jacks and the ¼” spacer to
the rear panel. Then solder the center pins of the SO239 jacks.
□
Step 8: Power Inlet –
Use two #6-32 X ½” screws and #6-32 hex nuts with integral lock washers to attach
the power inlet to the rear panel.
Please orient the inlet as shown with the ground tab up.