10
For D36 to D60 this bolt
doesn’t need.
Connect between post and
beam with corner bracket and
fix it with hexagon bolts M8x25.
For D36 to D60(Wide beam)
Insert the post into the base
hole, and fix with support
stand not to fall down.
Step1
Check if it is flat
and vertical, and
cast concrete.
Step3
Install the beam
connecting parts to beam.
Step2
For D72/D80 triple type
Wide beam type installation procedure
1
Installation of posts and beams
2
Installation to base hole
Insert the post into
the base hole, and
fix with support
stand not to fall
down.
Step1
Check if it is flat
and vertical, and
cast concrete.
Step2
Install as the side which the caution
label is attached comes inside.
Beam
Beam connecting bracket
(Parts box)
Washer M8
(Parts box)
Beam
Hexagon bolt
M8×85-22
(Parts box)
Washer M8
(Parts box)
Spring washer M8
(Parts box)
Cap nut
M8(Parts box)
Hexagon bolt
M8×25
（
Parts box
）
Anchor rod
Corner bracket
（
Corner parts set
）
Post
Support stand
Support stand
Caution label
15
Roof rafter
Middle frame
Gutter
B part
C part
C part
A part
Main frame
U-shape gutter
Roof rafter
guide fin
U-shape gutter
U-shape gutter
Drilling screw
4×10×8
（
Roof rafter set
）
■
A part detailed figure
■
Roof rafter drawing of the
middle frame and gutter part
※
Fix the roof rafter firmly adjusting
the processing parts.
■
B part detailed drawing
■
C part detailed drawing
Screw it guiding the U-shape gutter
of the gutter at B part (step2).
Screw it guiding the U-shape gutter
of the main frame at C part (step3).
Screw it guiding the U-shape
gutter of the middle frame at
A part (step1).
Set the roof rafter to the processing
part of the middle frame. Strike the
end to the guide fin of the middle
frame and screw it.
Step1
9
Installation of roof rafter
Screw to the gutter.
Step2
Screw it to the
main frame.
Step3
