Hobbytech 1.CRX.RTR, Instruction Manual

6

A

C

B

Pairing your receiver to your KT3S+

Place model on a block to prevent wheels from touching the 
ground. 

A

 Connect battery to ESC. Fix the wire correctly with the 

provided connectors.

You must check the signal of transmitter and receiver before 
you operating it at first.

Make sure TH Trim is on neutral

- TURN OFF THE TRANSMITTER AND RECEIVER -

B

 Press and Hold the BIND button on the receiver while 

turning on the receiver 

C

.

Release the BIND button when the LED flashes red.

While the red LED flashes, press the BIND button to select the 
frame rate.

- Faster flashes= high frame rate (7ms), for digital servo

- Slower flashes= low frame rate (15ms), for analog servo

D

 Press and Hold the BIND/EPA key of the Transmitter 

(1)

, 

and then turn on the transmitter 

(2)

, LED flahes green and the 

Transmitter will communicate with the receiver. Release the 
BIND/EPA button when the receiver LED is solid red, and the 
transmitter is solid green, then your receiver is paired with your 
transmitter.

BIND

D

(1)

(2)

HOW TO CONTROL YOUR MODEL

NEUTRAL POSITION

1. Pull up the trigger in order to brake or speed down
2. Pull the trigger in order to go forward or speed up

BRAKE / SPEED 
DOWN POSITION

FORWARD / SPEED 
UP POSITION

If the wheels operate in the opposite direction,  

operate the servo reverse switch (ST in position NOR).

NEUTRAL

LEFT

RIGHT