Hobbytech 1.CRX18-BL, Instruction Manual

4

5

POWER ON

Follow the steps below to turn on the transmitter:
1. Check to make sure that that battery is fully charged and installed correctly.
2. Toggle the switch to the [ON] position. When active the R.LED will be lit.
3.  Connect the receiver to power.
For safety always power on the transmitter before the receiver.

BINDING

The transmitter and receiver have been pre-bound before delivery. If you are using another receiver, 
follow the steps below to bind the transmitter and receiver.
1. Turn on the transmitter while holding the bind button to enter bind mode. G.LED will start flashing quickly.
• Once in bind mode release the bind button.
2. The receiver will enter bind mode automatically when powered on.
3. Once binding is successful the receivers and transmitter’sLED will remain solid .

Note:

  When binding, put the transmitter into bind mode first, then the receiver.If the Binding does not finish in 10s, The receiver 

will quit bind mode automatically.

This binding information only applies to the FS-MG41 and the HW-709/HW-711/FS-R4A receiver, different receivers may 
require a different pocedure to complete the binding process. Please visit the official FLYSKY website for the latest information 
on compatible receivers and their respective usermanuals.
Product information is updated regularly, please visit our website for more information.

STICK CALIBRATION

This function is used to set the neutral position for throttle and wheel.
Every transmitter is calibrated before leaving the factory, however if recalibration is required, please follow these steps:
1.  Turn and hold the wheel as far clockwise as it will turn, hold the throttle all the way forward, then turn on the transmitter in 

calibration mode.

• The R.LED and G.LED will flash twice.
2. Calibrate wheel: Turn the wheel completely clockwise, then completely counterclockwise.
• When calibration is completed the R.LED will be off.
3. Trigger calibration: Pull the trigger back then forward as far as it will go.
• When calibration is completed the G.LED will be off.
4. Once calibration is complete press the bind key to save and exit.

FAILSAFE

This function dictates what the receiver will do in the event that it loses signal from the transmitter, this includes servo position etc.

Setup:

Turn on the transmitter and make sure it is connected to the receiver. Hold the control surface at the desired failsafe position.
Press and hold the bind button for 3 seconds, if the G.LED starts flashing every 2 seconds then setup has been successful. 
Failsafe is now set and will default to these values when the receiver looses signal.

Note: 

The fail-safe function has no default set at the factory and as such must be set manually.If no failsafe setting has been 

set, then the receiver will not output anything when signal is lost.

POWER OFF

Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2.  Toggle the transmitter’s power switch to the off position. 

Make sure to disconnect the receiver power before turning off the transmitter. Failure to do so may lead to damage or 
serious injury.

E

NGLIS

H

F

RA

N

Ç

AI

S