Manual
of
Brushless Motor Speed Controller
HW-SM006ENG-20130311 Page 3 of 3
-
Program ESC With Transmitter (4 Steps)
NOTE:
1.
Each speed controller in the Quattro must be programmed separately.
2.
Please make sure the settings for each speed controller in the Quattro are same.
1. Enter program mode
1)
Switch on transmitter, move throttle stick to top
position, connect the battery pack to ESC
2)
Wait for 2 seconds, the motor should emit
special
tone like “beep-beep-”
3)
Wait for another 5 seconds, special tone like
“
” should be emitted, which means
program mode is entered
4. Exit program mode
There are 2 ways to exit
program mode:
1.
In step 3, after special
tone “
”, please
move throttle stick to
the bottom position
within 2 seconds.
2.
In step 2, after tone
“beep-----beep-----”(ie.
The item #8), move
throttle stick to bottom
within 3 seconds.
3. Select option (Programmable value):
You will hear several tones in loop. Set the value matching to a tone by moving throttle stick
to top when you hear the tone, then a
special tone “
” emits, means the value is set
and saved. (Keeping the throttle stick at top, you will go back to Step 2 and you can select
other items; or moving the stick to bottom within 2 seconds will exit program mode directly)
Tones
Items
“beep-”
1 short tone
“beep-beep-”
2 short tones
“beep-beep-beep”
3 short tones
Brake
Off
On
Battery type
Lipo
NiMH
Cutoff mode
Soft-Cut
Cut-Off
Cutoff threshold
Low
Medium
High
Start mode
Normal
Soft
Super soft
Timing
Low
Medium
High
2. Select programmable items:
After entering program mode, you will hear 8 tones in a loop with
the following sequence. If you move the throttle stick to bottom
within 3 seconds after one kind of tones, this item will be selected.
1.
“beep”
brake (1 short tone)
2.
“beep-beep-”
battery type (2 short tone)
3.
“beep-beep-beep-” cutoff mode (3 short tone)
4.
“beep-beep-beep-beep-” cutoff threshold (4 short tone)
5.
“beep-----”
startup mode (1 long tone)
6.
“beep-----beep-” timing (1 long 1 short)
7.
“beep-----beep-beep-” set all to default (1 long 2 short)
8.
“beep-----beep-----” exit (2 long tone )
Note
: 1 long “beep-----” = 5 short “beep-”
Note:
Please make sure the throttle volume is set
to 0 when the throttle stick is moved to the bottom
position and 100% at the top position
1. Enter program mode
2. Select programmable items
3. Select options (Programmable value)
4. Exit program mod
