29
28
Aerobatic Flight
continued
Loop: From a high altitude, push forward on the stick to build up
speed in a medium dive (about 30° angle to ground), then
steadily pull back on the stick and hold it until the aircraft goes
over the top of the loop. Exit the maneuver straight and level by
returning the stick to the neutral position as the plane nears the
bottom of the loop.
Tail Slide: Push forward on stick to build up speed in a dive
(about 30° angle with ground), then pull back on stick and hold
until plane is heading up vertically.
Using slight inputs of elevator and rudder, keep plane in vertical
position until airspeed bleeds off. Slide the throttle to the Off
position. The plane will halt forward momentum and then swivel
to head nose first down. This is the completion of the move.
Move the throttle slider to full-on and pull out to straight and
level flight by pulling back on the control stick.
Chandelle: Gradually pull back on the control stick until the
plane is going vertical. Once on a vertical heading, add right or
left rudder. Once the nose of the plane is heading toward the
ground, gradually pull back on the stick to exit the maneuver in
straight and level flight.
Step 17
CHARGER
CAPACITY
MAX. CHARGE RATE
*CHARGE TIME
HBZ6519 DC Peak Charger 1.8
1700mAh NiCd pack
1.8 amp
55 minutes
3000mAh NiMH pack
1.8 amp
105 minutes
EFLC2010 Summit DC Variable
1700mAh NiCd pack
4.0 amps
25 minutes
Rate Peak Charger
3000mAh NiMH pack
4.0 amps
45 minutes
*charge times are approximations only
Chargers and Charge Times
EFLC2010
DYN4048
You may also purchase an optional charger to allow for faster charging. The E-flite Summit™
(EFLC2010)
is a DC
powered variable rate
(.250 mA–4.5 amps)
peak charger ideal for charging 4–7 cell Ni-Cd and Ni-MH battery packs.
The Prophet Pro™
(DYN4048)
7.5 amp 12V power supply powers the Summit charger.
E-flite Summit DC Peak Charger
Dynamite® Prophet Pro
12V 7.5 amp Power Supply
5723_HBZ Aerobird X manual 12/15/03 1:55 PM Page 28
