EN
11
BNF • RTF
Super Cub S
Setup for Optional
Transmitters
To operate the SAFE system in this aircraft, set up
your optional DSM2/DSMX transmitter using the
chart below.
- SAFE Flight mode is selected using
Channel 5 signal (high, middle, low)
- Panic Recovery mode is selected with
Channel 6 signal (high, low)
IMPORTANT:
A transmitter with a 2-position Channel
5 switch will only allow the use of position 0 or posi-
tion 2 fl ight modes. If possible (refer to your transmit-
ter manual) assign Channel 5 in your transmitter to a
3-position switch to operate all 3 fl ight modes.
Refer to your transmitter’s manual for more
information about transmitter setup.
Non Computerized Transmitter Setup
(DX4e and DX5e)
Transmitter
SAFE
mode
switch
Panic Recovery Switch
SAFE Flight
Modes Supported
Throttle, Aileron, Elevator and Rudder in Normal Position
DX4e
(2pos switch)
ACT/AUX
switch
Trainer Button
2 Pos Flight Mode
DX4e
(3pos switch)
CH 5
switch
Trainer Button
3 Pos Flight Mode
DX5e
(2pos switch)
CH 5
switch
Trainer Switch
2 Pos Flight Mode
DX5e
(3pos switch)
CH 5
switch
Trainer Switch
3 Pos Flight Mode
Computerized Transmitter Setup
(DX6i, DX7S, DX8, DX9, DX18 and DX18QQ)
Start all transmitter programming with a blank model (do a model reset), then name the model.
Set Dual Rates to:
HIGH 100%
LOW 70%
DX6i
1. Go to the SETUP LIST MENU
2. Set MODELTYPE: ACRO
3. Set REVERSE: Gear Channel
4. Go to ADJUST LIST MENU
5. Set TRAVEL ADJ: Gear/Fmode (0)
100%; Gear/Fmode (1)
40%
6. Set FLAPS: Norm
100; LAND
100
7. Set MIX 1: ACT; Gear
Gear ACT, RATE D 0%; U + 100%, SW MIX, TRIM INH
Resulting in:
The Gear and Mix switches operate the 3 SAFE modes
Gear 0; Mix 0 = Beginner Mode
Gear 1; Mix 0 = Intermediate Mode
Gear 1; Mix 1 = Advanced Mode
The Trainer switch operates Panic Recovery
DX7S
DX8
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set SWITCH SELECT: Change all to INH then GEAR: AUX1, FLAP: GEAR
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse AUX1
Resulting in:
Flap/Gyro Switch operates the 3 SAFE modes (0 beginner/1 intermediate/2 advanced)
The Trainer/Bind button operates Panic Recovery
DX9
DX18
DX18QQ
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set CHANNEL ASSIGN: click NEXT to go to Channel Input Confi g: GEAR: D, AUX1: i
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse AUX1
Resulting in:
Switch D operates the 3 SAFE modes (0 beginner/1 intermediate/2 advanced)
The Bind/I button operates Panic Recovery