Step 3
Motor Test and Battery Discharging
CAUTION:
Keep everything clear of the
propeller. A moving propeller can cause
injury.
1. The buttons below the power switch
and labeled as "TH. Trim" are the digital
throttle trim buttons. With your boat on
the stand, turn on the transmitter and
install the battery.
2. If motor is running, make sure the throttle
trigger is centered at neutral and press
the "-" throttle trim button until the
motor stops.
3. Pull the throttle trigger back. Motor
speed will increase as the throttle trigger
is pulled back.
4. In order to fully discharge the battery, run
the motor at high speed until it shuts off.
If there is not enough charge in the bat-
tery to power the propeller, then proceed
to Step 4 (on next page).
5. When finished with the motor test, be
sure to disconnect the battery first, then
turn off the transmitter.
Summary of Contents for Zig Zag Racer 3
Page 2: ...Instruction Manual ...