6
For the Pad Eye you
will need to drill two
holes on the side of
the hull.
1. Measure the drill
location by attaching
the Furler Line
Assembly to the
Furler. Run the line
through the Fairlead
and straight back
along the rail of the
hull. Locate the hook
at the end of the Furl-
er Line Assembly and
mount the Pad Eye 5”
back of the hook. See
FIG 10 &12.
2. Thru-bolt the
Pad Eye to the hull.
Access the inside of
the hull from the seat
hatch or rear hatch
depending on your
kayak model.
3. Once the Pad Eye
is mounted stretch
the shock cord on the
Furler Line Assembly
and hook to the Pad
Eye. See FIG 11.
This
will keep the furler
line taut allowing
the furler to work as
designed.
6
13/64”” Drill Bit
13/64”” Drill Bit
FIG 10
FIG 11
