Hobo U23-002 Manual Download

Page: 4 / 4

Re-install end cap.

Line up the two small bumps on the end cap with the two notches at the end of the case and then
push end cap in and lock into place by turning clockwise just slightly until bumps prevent further
rotation.

Tighten dome nut.

Summary of Contents for U23-002

Page 1: ...Cable Sensor Dome Nut Grommet assembly installed on cable Cable Tie Grease Packet Required Equipment Adjustable Wrench Utility Knife Removing the Existing Cable Sensor 1 Unscrew the grommet from the c...

Page 2: ...or to the board 6 Disconnect the cable from the jack on the board pull straight out 7 Pull the cable out through the case 8 Discard cable dome nut and grommet Connecting the New Cable Sensor 1 Slide t...

Page 3: ...tight and then trim the end 6 Slide the board into the case Align the sides of the board with the grooves on the side of the case Push the board into the case until the outermost edges of the board ar...

Page 4: ...Line up the two small bumps on the end cap with the two notches at the end of the case and then push end cap in and lock into place by turning clockwise just slightly until bumps prevent further rota...

Brands by name

Search results

Summary of Contents for U23-002

Reviews:

Related manuals for U23-002

Brands by name

Popular brands

Hobo U23-002, Manual

Search results

Summary of Contents for U23-002

Reviews:

Related manuals for U23-002

Brands by name

Popular brands