Frequently asked questions (FAQ)
Q1: When the power switch is turned on, the FAN does not rotate, and no alarm sounds.
Case LED signal
Situation
1
Blue: flash
Orange: on
Red: off
No alarm
It means battery charge is too low. Wait for battery to fully charge
(green light is lit). If machine still can
’t be used after charging for 8
hours, the battery should be changed.
2
Blue: flash
Red: flash
No alarm
Machine hardware failure.
Please contact a local retailer or local authorized dealer for repairs.
Q2: HOBOT can
’t start up and it sounds an alert at the beginning of the self-test.
Ans: It means that there is too much or too little friction. Pease check:
(1)
Whether the cleaning cloth is too dirty.
(2)
Glass stickers and window film have a friction factor that is too low.
(3)
If the window is cleaned many times, the glass surface will become very slippery.
(4)
The glass surface will become slippery if cleaned several times in a low humidity environment
such as in air-conditioned room.
(5)
When starting up the device (pressing
, or
or
), keep it 10cm or more away
from the window frame to prevent the device from making an incorrect assessment.
Q3: The HOBOT slips and cannot detect the upper frame of window in
“Auto Up then
Down
”(
) mode.
Ans: Press
key and switch to
or
auto mode.
Q4: HOBOT cannot finish cleaning the whole window and stops in the middle area.
Ans: Press
or
auto mode to continue cleaning.
Q5: HOBOT slips and cannot climb up to the window frame.
Ans: (1) The friction factor is too low and may be caused by glass stickers or window film on the glass.
(2) The cleaning cloth might be too wet.
(3) If the window is cleaned many times, the glass surface will become very slippery.
(4) The glass surface will become slippery if cleaned several times in a low humidity environment
such as in air-conditioned room.
(5) When starting up (press
, or
or
), keep the device 10cm or more away
from the window frame to prevent it from making an incorrect assessment.
Q6: HOBOT does not move smoothly, or it moves irregularly.
Ans: (1) Cleaning cloth is too dirty. Please change out the cleaning cloth for a clean one.
(2) Glass surface has different friction factor areas due to glass stickers, window film, and so on.
Please limit use the HOBOT to certain areas of the window.
(3) The screw of the cleaning wheel might have become loose. Just tighten it.
Summary of Contents for 198
