- 9 - HOBOT
an angle close to the glass to prevent dropping.
(2) Switch the power-switch to “off”
(3) Check out whether electric poor-contact, cable broken or not.
Q8: What to do if HOBOT abnormally stopped and red lamp is flashing, without
alarm?
Ans:(1) User can move HOBOT to safe area by remote control, or pull HOBOT back
with safety rope. Slightly pull the safety rope at an angle close to the glass to
prevent dropping.
(2) Switch the power-switch to “off”
(3) Check whether there is air-leakage caused by gap, uneven window frame.
Safety information about power adapter/battery
Use only the power adapter supplied with this device. Use of other type of power
adapter will result in malfunction and/or danger.
Please use the proper electric outlet and make sure no heavy objects are placed
on the power adapter or power cord.
Allow adequate ventilation around the adapter when using it to operate the
device. Do not cover the power adapter with objects that will reduce cooling.
Do not use the adapter in a high moisture environment. Never handle the adapter
with wet hands.
Connect the adapter to a proper power source. The voltage requirements are
found on the adapter.
Do not use broken adapter, power cord or plug.
Do not attempt to service the adapter. There are no service parts inside. Replace
the whole unit if it is damaged or exposed to high moisture. Consult your HOBOT
dealer for help and maintenance.
The battery used in this device may present a risk of fire or chemical burn if
mistreated. Do not disassemble, short contacts, heat above 60
℃
(140
℉
), or
incinerate.
If you have to dispose of this old equipment, please take it to the local recycling
center for recycling electrical and electronic parts.
