Hodedah HI3DR-G, Assembly Instructions Manual

HODEDAH 

®

www.Hodedah.com

Assembly Of Drawers

3

Screw M3.5 x 14mm

18 Pcs.

2

Screw M4 x 32mm

15 Pcs.

4

Handle

3 Pcs.

8

(1)

Nail

24 Pcs.

(2)

x3

1.  Place panel 

I

 and 

J 

on each side of panel 

G

with Panel 

I 

and 

J 

's PVC dowel insert to panel

G 

's non-thru hole and Panel 

G 

's mini fix screws

insert into Panel 

I 

and 

J 

's thru holes as shown.

Then tighten mini fix on panel 

I 

and 

J 

clockwise to

lock mini fix up.

Next, tighten screw 

②

 to panel 

I 

and 

J 

's upper

thru holes to fix up to the panel 

K

.

2. Flip drawer with bottom side

up, place panel 

L

 onto the

drawer and align properly. Then

nail the

nails provided with hammer on

the border of panel 

L

 as

shown.The gap between 2 nails
should be about 100mm.
After that, place a drawer slide B

⑬

 with the small white roller

facing outward and with other

end tip touching panel 

G

 onto

each bottom side (angle) edge of

panel 

I

 and 

J

. Then

tighten 3 screws 

③

 on each

drawer slide B 

⑬

 (as shown).

Place and fix Panel 

M

 onto Panel

G

 by inserting the dowels onto

the non-thru holes at Panel 

G

.

Then tighten screw 

②

 to panels

M

 's thru holes to fix them onto

panels 

K

 and 

L

.

3. Flip the drawer over.

4. Tighten 2 screw 

④

 from inner side of panel 

G

 into the handle 

⑧

 holes.

(3)

4

Screw M4 x 32mm

6 Pcs.