HODEDAH
®
www.Hodedah.com
Assembly Of Top Drawer
(1)
(2)
COMPLETED
(4)
(3)
15
Lock
1 Set.
AIM
Handle
1 Pc.
1
1
8
Screw M3.5 x 14mm
6 Pcs.
9
Screw M4 x 32mm
10 Pcs.
13
Nail
12 Pcs.
Screw M4 x 32mm
2 Pcs.
-Place panel
Q
on each
side of panel
M
.
-Then, fasten screw
⑨
to
panel
Q
's lower thru holes
to fix them onto panel
M
.
-Next fasten screw
⑨
to
panel
Q
's upper thru holes
to fix up to the panel
R
.
-Flip the drawer over.
-fasten 2 screw
①
from inner side of panel
M
into the
handle
①
holes.
-Flip drawer with bottom side up, place panel
S
onto the
drawer and align properly. Then nail the nails provided
with hammer on the border of panel
S
.The gap
between 2 nails is about 100mm.
-After that, place a drawer slide B
⑲
with the small white
roller facing outward and with other end tip touching
panel M onto each bottom side (angle) edge of panel
Q
.
Then fasten 3 screws
⑧
on each drawer slide B
⑲
.
-Then tighten screw
⑨
to panels T 's thru holes to fix
them onto panels S, M and R.
-Disassemble the lock
⑮
into 5 parts ,then
install the lock
⑮
by insert the lock
⑮
's
cylinder into middle thru hole of panel
M
,
then fix the lock up.
-Then tighten screw
⑨
to panels
T 's thru holes to fix them onto
panels S, M and R.
