• Place the R28 battery hatch doubler in the center, flush with the front and rear and glue to R27.
• Glue the reinforcements R29 to the left and right to the doubler R28 and to R27.
Caution
: The square end of the reinforcement R29 must be flush with the side with the
notch
for the magnetic
closure in doubler R28.
The rounded side of the reinforcement is on the other side of the battery, hangs past about 8mm.
• Glue the magnetic holder R30 exactly to the middle of the notch with a notch F27.
• Glue the magnets R31 with epoxy.
Caution
: Observe the polarity of the magnets, they must pull towards each other.
• Glue the small sheet R32 flush to the nose cone.
• Place the battery hatch and slide it against the panel F32. (
do not glue it ; )
Note
: the battery hatch should slide on smoothly. If necessary, slightly sand the sides of R29
• Glue the rear panel R27 with approx. 0.5mm distance to the battery hatch.
• If the model is to be built as a sailplane, the nose cone can be built from parts SN1-8.
To do this, slide the parts one after the other onto a remaining piece of guide tube and glue them together.
Then glue the nose on the motor frame.
• Sand the fuselage according to sections A, B and C.
In
no
va
tio
n
As
se
m
bl
y
M
an
ua
l (
EN
) V
9
