• Join together the connectors L1.
• Glue the elevator L2 to the connector L1.
• Sand all elevator parts L1, L2 and L3 as well as rudder parts L4 and L5
Sand and bevel according to the shaded cuts in the plan.
Note
: Make sure that the specified rudder deflections are achieved.
The tail surfaces are mounted on the fuselage only after the covering.
• For the covering we recommend ORALIGHT for the wings and stabilizers.
Alternatively ORACOVER can be used for the fuselage.
The rudder can be covered directly with covering.
You can also find instructions at https://www.oracover.de/
• Carefully remove the covering from the gluing points to glue the control horns.
Caution
: do not damaged the wood. (
hint
: use a hot pin to melt covering for control horns)
• Glue the F27 wing anchor in position using
5M EPOXY
and glue the elevator and rudder.
• Glue the control horns.
5M EPOXY .
The rudder must be exactly at right angle to the elevator. (See construction
section no. 25)
In
no
va
tio
n
As
se
m
bl
y
M
an
ua
l (
EN
) V
9
