• Install the motor and the ESC.
Note
: To prevent the motor cable rubbing between the motor bell and the fuselage. Glue in a small piece of balsa
over the wires to the fuselage doubler.
• Install the servos (no screws yet). Set servo arms accordingly.
• Create Z bend on the pushrod R22 at one end and install on the servo arm.
• Insert (do not glue, see below
**
) the rudder horn L6 into the slot provided for the rudders.
• Insert the pushrod into the guide tubes and connect the servo arms at center.
Attach servos with screws.
• Bend the pushrod cables at the rear end at right angles and hang them on the rudder horn.
The rudder must also be at neutral.
• Secure the pushrod cables on control horn by sliding a piece of leftover guide tube R21.
**
When everything fits, the control horns are glued.
5M EPOXY
• Connect the servos and the ESC to the receiver and install the receiver.
• Mount the propeller according to their enclosed instructions and GO FLY (after doing your safety checks)!!
In
no
va
tio
n
As
se
m
bl
y
M
an
ua
l (
EN
) V
9
