• Glue the web spar for the center panel, part F9 to the lower sheeting F1 / F2.
• Glue the web spars F10 for the outer surfaces of the lower panel F5 / F6.
Caution
: make sure that you make a
left
and a
right
component.
• Line up the lower panels F1 / F2 and F5 / F6 at the rear edge up to the dotted line on the plan (evenly).
Temporarily
insert the respective outer ribs into the indentations. Use a soft pencil and draw a line from one rib
end
to the other. Use a sanding pad to sand down the angle at the trailing edge.
NOTE: The goal is to have the trailing edge at 0.5mm thick.
• The plywood ribs F11 should be glued to the middle rib F12 on both sides.
• Glue together F27 wing anchorage. Wing anchorage will be glued
AFTER
covering.
• Assemble and glue ribs F13 at their given positions on the sheeting F1 / F2 and on the web spar F9.
• Glue the center rib F11 / F12 and the reinforcement F12a at the specified position.
Line up the hole in the reinforcement with the hole of the lower sheeting.
• Attach the connecting ribs F14 to the sheeting F1 / F2 and to the web spar F10.
Caution
: The ribs F14 must sit against the angle of the spar F10.
The angle of the spar is what creates the V-shape of the wing.
In
no
va
tio
n
As
se
m
bl
y
M
an
ua
l (
EN
) V
9
