• Divide the edge strip F24 (triangular piece of balsa) in 2 even pieces.
• Glue the edge curves F24 flush to the outer parts of the surfaces.
• After the glue has cured, gently sand to match the airfoil.
TIP
: A sheet of paper or masking tape can be applied to the sheeting to protect it from damage during sanding.
Before gluing
, verify the V shape of the wingtips (approx. 37mm +/- 3mm at the tip).
Note
: It is important that the measurement is identical on both tips.
• Glue the Wingtips F25 and sand after curing.
• Carefully press the perforated area on the connection rib F14 with a knife.
• Dry fit the wing joiner F26 to the center panel with the arrows to the outside and verify the V shape. (Measure 55
+/- 3mm on the rib F21).
The connecting ribs should be flush to each other. If everything fits, glue both wing joiners F26 (with the arrows to
the outside) on the center panel. Use 5M
EPOXY
Warning
: The gluing surfaces for the spar and the sheeting must be flat/flush. The same also applies when
connecting to the outer parts.
• Glue the outer panels. To join the outer panels, apply epoxy to
both
connecting ribs F14 over the entire surface.
Verify the V-shape on both sides (dimension 55 +/- 3mm on the rib F21).
Note
: It is important that the measurement is the same on both sides.
In
no
va
tio
n
As
se
m
bl
y
M
an
ua
l (
EN
) V
9