• Glue the R6 pieces and clamp them together.
• Glue the parts R7 and R8 to each other and clamp until cured.
• Glue the nut R9 with epoxy.
Caution
: Ensure no glue gets into the threads.
• Verify the frames R6 and R11, servo frame R10 and the wing holder R7 / R8 that they all fit at right angles into
the corresponding slots of the doubler R3 of the right fuselage.
Glue to right side.
Note
: For R6, the notch for the wing anchor points upwards (see section A),
In the case of the frame R11 the holes are pointing upwards (see section B).
• Mark the installation location for the R12 bulkhead.
• Glue R13 in position.
• Glue the left side of the fuselage. Use weights or small clamps. Keep everything aligned until cured.
In
no
va
tio
n
As
se
m
bl
y
M
an
ua
l (
EN
) V
9