How to solder
1. Thoroughly clean and remove oil and other contami-
nants from parts to be soldered.
2. Use only small amounts of solder. Excess solder can
cause a short circuit.
3. Slide switch to ON position and press and hold the
power button. The LED light will illuminate indica-
ting the iron is on.
4. Allow tip to reach working temperature (about 10
seconds). Apply a small amount of solder to tapered
surface of tip. Remove excess solder with a damp
soft rag or sponge.
5. Tin wires by heating the bare wire and allowing a
small amount of solder to flow onto the tip of the
wire.
6. Touch the tapered surface of the tip (not the point)
to the joint to be soldered. Heat joint and allow heat
from joint to melt solder.
7. Allow a small amount of solder to flow into the joint.
8. To ensure a strong joint, do not touch or move the
joint until it has cooled completely.
How to replace tip
9. Ensure switch is in the OFF position. Allow tip to
cool completely before replacing tip.
10. Use only genuine GH-200hSI replacement tips.
11. Unscrew old tip by rotating translucent locking nut
counterclockwise.
12. Screw in new tip by rotating translucent locking nut
clockwise until it snaps on lock position.
Note
: Align the Notch on the housing to install the
new tip.
13. Do not file tip.
Charging
Connect the micro USB side to the end of this tool, and con-
nect the USB side to your PC or wall charger. It will take 3.5
hours to fully charge. Once fully charged, the indicator light
will turn green.
Tips
§
TIP01
• 12 W-soldering
• Ideal for soldering on the electrical/electronics,
circuit boards etc.
• Working time: 40 min.
• max. temperature: 600 °C
ready to start in 8 seconds
§
TIP04
• 30 W-soldering
• Ideal for heavy duty soldering works, such as
• copper plate or solid copper wire connection,
• stained glass projects.
• Working time: 40 min
• max. temperature: 600 °C
ready to start in 8 seconds
§
TIP06
• Suitable for Shrink Tube
(less than diameter 4.0mm)
• Working time: 45 min.
• ready to start in 2 seconds
Manual for soldering set
Art.
WLK/E
Summary of Contents for WLK/E
Page 8: ...Art WLK E...
