18
GB
06 Operating
manual
Finally: you are about to bathe for the
fi
rst time in your HOESCH whirl tub! We wish you a lot of pleasure in your new
bathtub! The fact that you have a highest quality product is the effect of constant monitoring of the product, research
and development works in connection with the innovative design of our luxurious bathtubs made of sanitary acrylic.
However, in order for your bathing not to be disturbed, we suggest reading this manual
fi
rst.
07 Introduction
07.01 How does the ERGO+ whirpool system work?
The whirl system has a closed water circulation. The drain valve is at the same time the sucking connector. Water is
sucked in/ out, the whirl pump accelerates its
fl
ow so that the water under the pressure of approx. 1 bar is forced in by
massage jets to the inside of the bathtub. Thanks to the generated negative pressure an automatic air enrichment takes
place (this function can be switched on and off with the use of the remote control). Pipes between the jets and the pump
are located in such a way that they get empty during draining the bathtub. The air blower mixes the air in the ERGO+
system to give stronger and more powerful massage, reaching all parts of the body.
08 Equipment
08.01 Standard equipment
Hydromassage jet
Jet in the bottom
of the bathtub
Remote control pilot
08.02 Additional equipment
Colorful lighting diodes
Heater
Summary of Contents for ERGO+ Series
