28
6. Remove the water container from the back of the appliance. Fill it with water.
The water level must be between the minimum (MIN) and maximum (MAX) level
markings on the container. Replace the container.
7.
Install the portafilter with the filter basket - follow the procedure described in
section
7.5 Portafilter installation
. Do not put coffee into the filter basket. Make
sure that the portafilter has been correctly installed and its handle is aligned with
the
LOCK
symbol.
8. Place a cup/mug on the dripping tray, directly below the coffee nozzle. Make sure
that the steam control knob is in the OFF position.
9.
Insert the power cord plug into the outlet socket (the socket must be equipped
with a protective ground pin).
10. Press the button to switch on the appliance. A red LED placed next to the
button will be lit.
11. Press the
button to start the coffee pouring process. As soon as water starts
coming out, press the button again to stop the process. Press the steam button
and wait for a while until the appliance is heated. A green LED next to the
symbol will be lit.
12. Press the
button to start the first rinsing process. To stop the process, press
the
button again. Repeat the process until all the water from the container is
used.
13. When water stops coming out, remove the water container, clean and dry it. Wash
the cup/mug used for first rinsing. Now you can start brewing coffee.
Attention!
A disturbing noise may be heard when the appliance is rinsed and water
comes out from the nozzle. This is normal when the appliance releases air and steam.
7.2 Preheating
To make sure that the brewed coffee is hot, the water used to make it should be
preheated. In order to preheat water follow the instructions contained in items 1
through 6 in section
7.1 Before use
.
Summary of Contents for CM-0473
Page 1: ...EKSPRES CIŚNIENIOWY ESPRESSO MACHINE INSTRUKCJA INSTRUCTION MANUAL ...
Page 2: ......
Page 39: ...39 ...
Page 40: ......
