Passenger Tire Changers Service Manual 07-13 Rev.B
12
Remove the disc acting with a screwdriver on the side tabs
Loose the screws and remove the frame switch.
Take the switch out from the inverter box.
Check wires continuity from power supply plug to main
switch wires terminals.
Cross the wire check to make sure that any wire in short circuit.
IMPORTANT! TO CHECK GROUND (YELLOW/GREEN) WIRE, DISCONNECT THE WIRE END FROM THE
TERMINAL BLOCK.
TO REPLACE THE CABLE:
Disconnect the power supply wires from the plug and switch terminals.
Disconnect the ground wire from terminal block.
Release cable strain relief from the inverter box.
Remove plug from cord and take the defective cable away.
Insert the new cable through the strain relief.
IMPORTANT! USE ONLY APPROVED CABLES, PLUGS. GROUND WIRE MUST BE LONGER THAN THE
OTHER ONES.
Fix new faston on inside cable ends and connect them to the switch terminals and to the plug.
Fix the main switch to the electronic box.
Install the disc.
Mount again the switch knob and cover of the screw.
Connect the ground wire to ground terminal block.
Install
plug.
Tighten strain relief
FIRMLY
.
Plug the machine to the wall.
Check if the machine works fine.
Disconnect the power supply.
Fix the inverter box again to the cabinet.
