Passenger Tire Changers Service Manual 07-13 Rev.B
41
Install the two front adjustment screws and turn them until end of
stroke.
Then turn them back of two turns.
Block the counter nuts.
Install the two screws with springs. Tighten them for about
10mm
Tighten the cylinder adjustment screw: when the screw will touch
the washer turn the screw of two more turns.
Connect the air pressure and the power supply.
For the mechanical adjustment refer to chapter 7.2.
Check if the machine works fine.
6.5 VERTICAL ROD LOCKING CYLINDER ON 22”: CHECK AND REPLACEMENT
:
30’
: Allen key 3,4,5 and 6mm, 17mm end key, 13mm tube type key
: Defective vertical locking cylinders may cause the following malfunction:
1.
Air leaking from the cylinder.
2.
The vertical rod does not remain blocked.
TO CHECK THE CYLINDER
Disconnect the air pressure from the machine
Remove
the
cover.