13
Instruction Manual
MORSØ Notch Cutting Machine
Model NXLEH
Cutting Method
Adjustment before cutting:
The knife block (1) is in top position.
The clamping cylinders (2) are adjusted manually 5 – 6 mm from the work piece.
A)
Automatic cutting - cycle for work pieces
The knife block (1) is in rear position.
Switching contact (10) is in position “0”.
Switching contact (11) is in position “ON”
(the clamping cylinders (2) are activated).
By activating pushbutton switches (3) + (4) (two-hand-operation) the clamping cylinders (2)
press the work piece against the movable fence (7) and the cutting cycle begins (the last cut
is a so-called trim-cut).
Conveying cylinder (5): horizontal movement (forward and backward) of the slide frame part
(6).
Hydraulic cylinder (8): Vertical movement (cutting function) of the knife block (1).
If you during cutting require bringing the knife block backwards and releasing the clamping
cylinders (2), the pushbutton switch (3) is activated separately.
B)
Automatic cutting with smaller length of stroke of the knife block (1).
The length of stroke can be adjusted in two fixed positions with switching contact (9)
according to the height of the work piece. Thus you avoid a too long vertical movement of the
knife block. The cutting cycle remains the same as at the automatic cutting.
Functional Description
C-5
