46
-Position the wheel on the roller unit vertically, with the outside of the rim
facing right.
-Lift the wheel completely with pedal F positioning it on the turntable.
-Lower the hoist by releasing pedal F and place the wheel on the turnta-
ble; press pedal V to lock the wheel.
13.0 ADJUSTING THE TURNTABLE LOCKING MEASUREMENTS
Before locking the wheel check the adjustment of the turntable and the dimensions of the wheel to lock. The tyre
changer’s turntable is adjusted by the manufacturer at an intermediate measurement that goes from 10” to 20” ext
(in relation to the outside of the rim) and from 12” to 22” int. (if the wheel is locked from the inside).The adjustment
can be done by turning the two knobs located under the plate, between the two pneumatic cylinders (fig. 16). To
increase the locking diameter, turn the knob to the right (+) and, observing the decal (fig. 17), match the pin of
cylinders P with the number of inches to increase. For example, if we turn the knob until the reference pin matches
1 we have a 1" increase, and so on.
V
F
fig. 16
P
12.0 LIFTING THE WHEEL AND LOCKING IT ON THE TURNTABLE
Before lifting the wheel and positioning it on the turntable, remove all the counterweights from the rim with a su-
itable tool, being very careful not to damage the rim and check that all the tools are out of the hoist’s trajectory
(optional).
Summary of Contents for Megamount 703 XL
Page 80: ...80 24 DATI TECNICI TECHNICAL DATA DONNEES TECHNIQUES TECHNISCHE DATEN ...
Page 83: ...83 110V 1PH ...
Page 85: ......
