20
4.2-1
4.2-2
13
9
5
1
3
2
11
6
10
12
8
4
7
Layout
8. Weight key
Press to select the required weight application
mode (weight mode), the unit will beep.
F+Weight key; activates the Motorcycles wheel
balancing Mode.
9. Stop key.
Press to stop spinning the wheel.
The STOP key also has an emergency stop
function.
10. g/oz key.
Toggles between reading in grams and in ounces,
and vice versa.
F+g/oz; activates the C-Code functions (refer to
Chapter 5.10), special user functions.
11. Static/Dynamic key.
Toggles between dynamic and static modes.
Stat/Dyn key activates the function for balancing
with a stick-on counterweight inside the tyre.
The INT LED on the panel lights up.
Note:
The Static mode can only be selected after
the measuring run.
12. SWM key, hidden weight split and mm/inch Key
Press to select the SWM function, hidden weight
split. This can only be activated after selecting the
ALU2P/ALU3P application mode.
In combination with the “F” key, toggles between
readings in inches (default setting) and millimeters.
13. START key.
Starts the machine spinning the wheel.
4.3
Main shaft lock
Fig. 4.2-2
Pedal of main shaft lock
The main shaft is locked when the pedal is depressed.
This facilitates tightening or untightening of the
clamping nut and retains the wheel in the correction
position for correct fi tting of the balance weights.
Note
:
This lock is designed only to facilitate orientation
of the wheel and must not be used for braking the
main shaft.
..
..
..
.
.
10. g/oz key.
Toggles between reading in ounces and in grams,
and vice versa.
Summary of Contents for geodyna 7100
Page 94: ...94 Blank Page ...
