154
........ ..
7-2
7-1
Trouble shooting
7.1 System messages
The wheel balancer can send messages to the
operator relevant to errors (E codes) (e.g.
E2
-
Fig. 7-1
),
warnings (H-codes) (e.g.
H 33
-
Fig. 7-2
) or Hardware
problems (X-codes). The codes will be described in
the following chapters.
Whenever a code appears:
•
Make a note of it.
•
Look up the code in the list below.
•
Perform the steps described.
Important:
If the code is not listed here, call service team.
Command Error
-
Message E
Warning
-
Message H
Fatal error
-
Message 300 or C10
7.1.1 E codes
E1
Rim dimensions were entered incorrectly, or
incompletely.
When the message is displayed, enter data once
again.
E2
Wheel guard is not closed.
E3
Geodata
gauge for distance and rim diameter is not
in home position.
E4
The
Geodata
width gauge arm is not in home position.
E5
Range of compensation exceeded (wheel adaptor has
unacceptable unbalance).
Press the
STOP
key or
ESC
key.
Check wheel adaptor, repeat compensation run.
E6
During the recalibration the calibration weight was
not fitted.
Press the
STOP
key or
ESC
key.
Repeat readjustment.
E7
With this wheel type it is not possible to choose a
weight positioning type.
If necessary, choose another wheel type.
Summary of Contents for Geodyna 8200 Series
Page 188: ...188 Blank Page ...
