180
........ ..
a
b
c
d
e
f
3
1
7-4
7-6
7-7
7-8
1
2
3
Setting Parameters
7.5 Counters
Every measuring run actually completed is stored.
Maximum count is 999,999 runs.
Once this number is reached, the counter is reset to
zero. The information is primarily useful for statistical
purposes, e.g. to obtain evidence of load intervals of
parts when defective, or of monthly (yearly) use of the
machine, etc. The measuring runs performed while
the machine is on are transferred into the permanent
memory and added when it is switched off. The counter
cannot be deleted or changed.
In the SETTINGS screen (
Figure 7-4
), select the
“Counters” category (
1, Fig. 7-6
).
The data immediately available in the Values field are
the following:
List of Counters
(
Figure 7-6
)
a
Total runs
= Total number of measuring runs
completed
b
With OK
= Total number of measuring runs
completed
with
b a l a n c i n g
result OK
c
Optimisations = Total number of optimisations or
minimisations
d
Service runs = Total number of measuring runs in
Service mode
e
Since last
= Total number of measuring runs
completed
calibration
since the last calibration.
f
Clamps
= Total number of wheels clamped
7.6 Promotional text
Select the “General Settings” Category in the
SETTINGS screen, then select one of the 5
“Promotional Text” Parameters in the central panel
(
3, Fig. 7-7
).
After the selection a keyboard is displayed with the
text entry field.
To switch to upper case and additional special
characters press key (
1, Fig. 7-8
).
To go back by one position in the text, press key (
2,
Fig. 7-8
).
To close and enter the current text string, press
“
ENTER
” (
3, Fig. 7-8
).
The promotional text, saved automatically, will appear
in the
Main Screen
INTRO SCREEN
exactly as
entered by the user.
Summary of Contents for Geodyna 8200 Series
Page 188: ...188 Blank Page ...
