11
9.1-6
F5
F4
F3
F2
9.1-5
F5
9.1-7
Note:
The change in the position of the weight
is saved by the machine, then
automatically suggested for all subsequent
wheels with the same dimensions. The
selection is deleted when the machine is
switched off.
F2:
the top part of the key is described in the geodyna
6800 basic model instructions. The bottom part of the
key changes the weights application mode. The
normal mode is accessed by pressing the key for
longer (clip balance weights).
Note:
The possible application of the weights in
ways other than that suggested by the
machine is indicated by the grey weights
in the positions compatible with the rim
configuration detected.
Note:
The change in the weight application mode
is then automatically suggested for all
wheels with the same dimensions, until
the machine is switched off.
F3:
The upper part of the key is described in the geodyna
6800 basic model manual.
Use the lower part of the key to select the Vehicle Type
to be operated on. There are three vehicle types
selectable (fig. 9.1-5): CAR, SUV, TRUCK, with runout
limits suitable for the class of vehicle set for each. The
limit values assigned separately to each Vehicle Type
are:
- First harmonic Wheel radial Runout,
- Peak to Peak Wheel radial Runout and
- Tread Depth.
The values can be changed individually and saved by
the user in the "OPTIMA PARAMETERS" menu.
F4:
prints the diagnostic report (the printer must be
active). Pressed again it interrupts the current print (in
this case the key will be blocked).
F5:
activates the mode on the spokes. For a correct
detection the spokes on the rim must be equidistant,
of a regular shape and of a minimum number of 3
and maximum number of 12. If the number of spokes
has been detected correctly, a check mark will appear
on the relative key (fig. 9.1-6). If the spokes cannot be
detected, the pictorial as shown in Fig 9.1-7 is displayed.
Pressing F5 will display the values of the two separate
weights to apply on the wheel. Therefore it will not be
necessary to introduce the reference spoke location
data as it has already been detected by the control
software. Proceed directly with the application of the
wheel weights. To exit the Spoke mode, press F5 once
again or remove the wheel.
Summary of Contents for geodyna optima
