27
11.1-9
11.1-10
11.1-11
WHEEL No. 2
•
Mount the wheel on the balancer shaft.
•
Perform the run.
•
Balance the planes and make any corrections
suggested by
optima
.
•
Remove the wheel from the balancer.
The screen page shows the wheel with the number after
the previous one and a different colour (Fig. 11.1-9).
•
Select one of the keys
F3
,
F4
or
F5
to enter the
current wheel in the set.
The
"SET OF WHEELS 2"
screen page appears
automatically (Fig. 11.1-10).
Note
: After selecting key
F3
or key
F5
twice in the
procedure, the program does not allow
you to select this key again.
You cannot assign more than two wheels
to the same side of the vehicle.
WHEEL No. 3
•
Perform the procedure as described for wheel
No. 2.
WHEEL No. 4
•
Perform the procedure as described for wheel
No. 2.
At this point of the procedure the machine already has
a first mounting suggestion.
The box on the right shows the number and colour of
each wheel in the appropriate mounting position on the
vehicle (Fig. 11.1-11) for optimising the PULL.
You can now select one of these options:
"Optimise vibrations"
,
"Enter fifth wheel"
"Start a new Set of Wheels"
, or
"Terminate and exit procedure"
as described below.
Summary of Contents for geodyna optima
