31
12.0 Error codes
Note:
E Prefix = Errors in operation
H Prefix = Warnings
The error codes are displayed for ca. 3 seconds on
the left of the screen above the F1 menu key with an
E followed by the numerical code (e.g. E10).
Use the HELP key to call up a help text (installed as
of version 1.34 of the software).
•
To cancel the error message, the error must be
removed (e.g. open the wheel guard) or press the
STOP or ESC key.
The error messages with reference to the optima wheel
balancer functionality are described below:
E1
Rim dimensions incorrect or incomplete.
•
Repeat rim data input.
•
If the problem persists, you can have a manual
data entry by pressing F1 in the balancing
screen.
E30
No runout detection.
•
Repeat the measuring run to determine the
runout detection.
•
If the problem persists call service.
E31
If the operator, following a rim profile reading,
chooses to proceed with a complete wheel
measurement, the control software prevents the
operation because only the presence of the rim is
detected.
•
Fit a tire on the rim.
E32
The user selected to proceed with a bare rim
measurement but the machine actually detects
that a complete wheel is on the machine.
•
Mount a bare rim.
Summary of Contents for geodyna optima
