43
E396
Rear motor missing steps
Possible causes:
•
the rear scanner movement is not smooth or it
is striking the frame
•
the motor power supply is not configured
properly
•
there is a fault in the motor power supply board
•
there is a fault in the rear scanner motor
•
there is a fault in the camera controller board
motor drivers
•
the cable connecting the camera controller
board and the rear scanner motor is partially
unplugged or damaged
Corrective actions:
•
check all items above.
E397
Rear laser current sink or power supply failure
Possible causes:
•
the flat cable connecting the camera controller
board and the rear scanner CCD board is
unplugged, missing or damaged
•
the cable of the laser module of the rear
scanner is damaged or there is a fault in the
laser module itself
•
there is a fault in the camera controller board
laser drivers
Corrective actions:
•
check all items above.
E398
Rear laser modulation failure
Possible causes:
•
the flat cable connecting the camera controller
board and the rear scanner CCD board is
unplugged, missing or damaged
•
the cable of the laser module of the rear
scanner is damaged or there is a fault in the
laser module itself
•
there is a fault in the camera controller board
laser drivers
Corrective actions:
•
check all items above.
Summary of Contents for geodyna optima
