6
P/N: 8-23562A
P/N: 8-23562A
Part Number: EAL0408G44A
Operator Manual
Safety Label Meanings
WARNING
:
MAKE SURE THAT THE SAFETY SIGNS ARE ALWAYS
CLEARLY VISIBILE IN THE POSITIONS INDICATED BY
THE MANUFACTURER.
For any reset, use the Part Number (P/N) listed in this
charter.
EAL0408G77A
Risk of fl
ying fragments during beading.
•
The beading operation with the GT device can
result in fl ying objects and loud noise levels.
We therefore recommend the use of protection
equipment for eyes and ears.
•
When using compressed air for the beading
operation there is the risk of the tire exploding.
•
Avoid excessive pressure. Do not exceed the
maximum pressure indicated on the tire.
•
The risk of explosion is also dependant on the
conditions of the tire. Check the tire before
infl ating it.
Exploding tires can cause death or serious injury.
8-23562A
Risk of electrical shock.
•
Do not operate equipment with a damaged power
cord or if the equipment has been dropped or
damaged, until it has been examined by a qualified
service person.
•
If an extension cord is necessary, a cord with a
current rating equal to or greater than that of the
equipment should be used. Cords rated for less
current than the equipment can overheat.
•
Unplug equipment from electrical outlet when not
in use. Never use the cord to pull the plug from
the outlet. Grasp plug and pull to disconnect.
•
Do not expose the equipment to rain. Do not use
on wet surfaces.
•
Plug unit into correct power supply.
•
Do not remove or bypass grounding pin.
Risk of electrical shock. High voltages are present within
the unit.
•
There are no user serviceable items within the unit.
•
Service on the unit must be performed by qualified
personnel.
•
Do not open any part of the unit other than noted
and allowed areas.
•
Turn power switch off and unplug the unit before
servicing.
Contact with high voltages can cause death or serious
injury.
IMPORTANT!! SAVE THESE
INSTRUCTIONS
Summary of Contents for Monty 1270 Smart
Page 54: ...54 B L A N K P A G E ...
