15
6.0 Maintenance
WARNING
BEFORE ATTEMPING ANY MAINTENANCE OR
REPAIRS THE MACHINE MUST BE DISCONNECTED
FROM THE AIR AND ELECTRIC SUPPLY.
A. Periodically clean the vertical hexagonal rod with
nonflammable liquid detergent. Lubricate with oil (Fig.24).
B. Periodically clean all moving metal parts and lubricate
with oil.
C. Clean the teeth of the clamps with a wire brush, check
the plastic rim protectors and replace if worn (Fig.25).
D. Periodically replaced the plastic insert inside mount/
demount tool.
E. Lubricate rods of air cylinders with oil as needed.
F. Periodically wash all plastic parts with cold water and
soap or window cleaner.
G. Check the bead breaker pads. Replace if worn.
H. Discharge the water every day from air filter
I. The machine is equipped with an automatic lubricator.
Check the oil level weekly. When adding oil to the lubricator,
disconnect the air supply first, remove the fill screw ‘A’,
and add oil as needed. Make sure seals are in place when
repositioning the cup
Drain water daily from water separator. Do this by pulling
down the fitting ‘B’ (Fig.26).
WARNING!
PAY ATTENTION TO KEEP FILLED THE OIL TANK OF
THE OILER.
WARNING!
USE ONLY OILS FOR AIR DEVICES, DO NOT USE
BRAKE FLUID OR OTHER NON SUGGESTED
LUBRICANTS.
Suggested oils for the filter/lubricator unit:
10W Non detergent / Air tool oil.
538
6.0
6.0
6.0
6.0
6.0
642
6.1
6.1
6.1
6.1
6.1
967
6.2
6.2
6.2
6.2
6.2
