Seite 71 von 99
4. Manual Data Entry
The nominal rim dimensions of the wheel can be entered by using the offset, width and diameter keys.
These keys can be used when the balancer is idle. That is, there is no spin in progress and no other
functions are in use.
To enter a value press the appropriate key. The led next to the key will light and the current value will be
displayed (offset in left panel, diameter and width in right panel).
Enter the value using the "plus" and "minus" keys. Holding the keys down will cause the value to
increment / decrement automatically at an increasing rate. The value can be stored and the function
exited by performing any of the following actions;
•
Starting a wheel spin (see below).
•
Pressing the "return" key or the dimension key which is in use.
•
Pressing another dimension key to edit another value.
•
Pulling out the sape.
Exiting the function using any of these methods causes the relevant dimension led to turn off, saves the
value and may cause a result recalculation. A beep is heard upon selecting and exiting this function.
B9000 / B9450 Specific Features
Only Diameter can be entered while in a hidden weight mode (width and offset are not required, weight
offsets are entered with the sape). The rim diameter range in HWM modes is reduced due to the
mechanical constraints of using the gauge arm to apply the weights. For this reason, HWM modes will
only allow results to be displayed if the rim diameter is within range.
B9460 Specific Features
No manual data entry can be performed during HWM modes with the b9460 balancer as both offset and
diameter are entered via the 2D sape.
Value limits are:
Width
80 - 510 mm or 3 - 20 inches.
Diameter
205 - 635 mm or 8 - 25 inches in all modes.
12 – 25 inches in Hwm1 or HWM2 modes with inches selected.
Offset 1 - 500 mm.
Increments are;
Inch
0.25 or 0.5 depending on size of value (0.25 below 10.0)
MM 1mm.
Summary of Contents for Snap-on Y2k
