154
Section 5 - Scheduled Maintenance
Step 8 (cont)
Set the thrust housing cap on top of the thrust
housing and carefully press it into the housing.
Align the bolt holes in the cap to the threaded
holes in the thrust housing. Apply Anti-seize
to the 3/8” Allen bolts and hand tighten using a
crisscross pattern. Use the 6mm Allen wrench
to tighten the thrust housing cap bolts to “snug”
using a crisscross pattern. Figure 16.
1
2
3
4
5
6
Step 9
Install the High Pressure Water Hose and Grease the Thru-Shaft Bearings.
Apply anti-seize to the threads on the top of the thrust housing cap and install the high pressure water
hose. Hand tighten the hand nut on the pressure hose.
Use a grease gun and apply grease to the thru-shaft bearing until grease comes out of the relief hole
on the side of the thrust housing.
Pressure Water
Hose Hand Nut
Grease Fitting
Relief Hole
Figure 16: Apply anti-seize to the thrust housing bolts and
tighten them in a crisscross pattern to snug
using a 6 mm Allen wrench.
Figure 17: Apply anti-seize to the thrust housing threads
and install the high pressure water line.
Figure 18: Thru-shaft bearing grease fitting and grease
relief holes in thrust housing base.
Summary of Contents for STRIPE SH7500
