---------------------------------------------- pg13 ----------------------------------------------
---------------------------------------------- pg6 ----------------------------------------------
----------------eXerbike Upright Cycle User Manual-----------------
----------------eXerbike Upright Cycle User Manual-----------------
Cleaning the Operating Status Window
The eXerbike Upright Cycle display panel is protected with a
polycarbonate plastic finish. Strong cleaners, solvents or abrasive
materials can dull and scratch the finish making the displays hard to
read. We recommend cleaning the display panel with clean water or a
mild cleaner.
Moving eXerbike Upright Cycle
Your eXerbike Upright Cycle has two wheels in the back of the unit.
One person can easily move the unit. Lift the rear of the unit until the
plastic wheels on the front of the frame are engaged and then move the
unit by pushing or pulling.
Changing Batteries
The four D-cell batteries that power eXerbike Upright Cycle Operating
Status Window are located inside the consolewith access underneath.
Use the following procedure to change the batteries:
1. Remove screws holding plastic console backing.
2. Reach inside and disengage the two velcro straps that hold the
battery tube.
3. Note the direction of the positive and negative ends of the batteries,
slide out as a single unit. Be careful do not drop into cover
4. Slip the new batteries into the sleeve so they all face the same
direction.
5. Place batteries into the holder with the positive end facingthe red
wire. Secure the batteries with the velcro straps.
6. Check operation of Operating Status Window.
7. Check if electronics are operating correctly.
8. Re-Install screws to secure plastic console backing.
Resistance Level Control
The Resistance Level control determines how hard the pedals are to turn.
To increase the amount of resistance turn the knob clockwise. Turn the
knob counterclockwise to decrease the resistance.
Seat Adjustment/ “Step Thru” Feature
The seat should be adjusted to a comfortable position when using
HOGGAN Sprint “Step Thru” Upright Cycle.
Instructions:
1. Do not sit on seat while trying to
adjust the seat height.
2. Locate knob under the seat
andpull knob away from the seat
post.
3. Adjust/Slide seat up or down to
desired position.
4. Release knob until seat engages
in frame.
Summary of Contents for eXerbike
Page 1: ...User Manual...
