13
4.7 Recline (trough shaped backrest)
• Remove the rear wheel and the wheel guard as described under
„3 Delivery and preparing for use“.
.
• Loose and remove both hexagon socket screws.
• Repeat that on the opposite side too
• Tilt the backrest and choose one of the five backrest angles (see
marking).
• Tighten all fasteners firmly.
4.8 Recline (angle- and height adjustable backrest)
• Hold with one hand the upper edge of the backrest panel as
shown.
• Pull the bowden cable until the bolts are completely withdrawn into
its housing.
• Now one of the five backrest angles can be chosen.
• Release the bolt to lock into the required position.
CAUTION!
Check with a sharp push on the backrest to ensure that
the bolt is securely located.
4.9 Active degree
The active degree describes the relation of the backrest position
to the rear wheels. The more the backrest is positioned to the rear
of the axle, the more active the
SWINGBO PLUS
can be driven.
(e.g. lifting of the front wheels). That means contrary a safer driving
position if the adjustment is set above or in front of the rear axle.
The active degree is adjustable in 6 steps (0-5) by sliding the axle
unit (38).
CAUTION!
Adjustments with a high active degree demand a
practised driver and the use of an anti tip.
The
SWINGBO Plus
will be built in accordance with the
customer’s order. It is possible for the dealer to modify the
active degree.
4.10 Tilt
• Lock both wheel locks.
• Pull the release handle (39) until the locking mechanism is fully
disengaged.
By using the push-bar or push-handles, the seat unit can be adjusted
to any angle between -7° and +45°. Set the required seat angle and
allow the bolt to lock in the required position.
CAUTION!
Push sharply on the push-bar or push-handle to ensure
that the bolt is securely located.
36
37
38
39
40
