4
ReV 225-RM aMplIFIeR
InStallatIon InStRuctIonS
Step #1: Over top of the radio, pull up to release each wire harness from the
black plate via the factory “Christmas tree” fasteners. If your bike has
factory GPS, the small square antenna will need to be relocated just
behind the voltmeter as shown in Fig 1.1 below. Remove the four factory
T-20 “Torx” screws that go through the top of the black plate and into
the top of the radio.
Step #2:
Step #3: The amplifier comes on a black mounting plate and needs to be
separated from that plate. Sit the amplifier plate over top of your radio
and re install the factory screws to secure the amplifiers mounting plate
to your bike noting the plate can only go on one way. Locate the supplied
input harness and plug into the “audio input” socket on the side of the
amp. Locate the “front output” harness with brown/ black and blue/
black wires and plug it into the 4 pin BLACK plug on the pig-tail coming
out of the amp. You will now put the amp back in place. For reference, if
you are standing in front of your bike looking down at the plate, the amp
will go to the extreme left so the power harness is closest to you. When
sticking the amp in place, position the 4 pin black plug on the pig-tail so
its sitting on top of the amp. This will allow the amp to sit as close to your
gauges as possible and allow the outer fairing to go back on. There is a
“tab” on the front and side of the amplifiers mounting plate which allows
you to re-attach the wire harness using the factory Christmas tree fastener.
Figure 1.1 - The white circle shows the new
location for GPS Antenna if the bike came
factory equipped with this feature.
Summary of Contents for G4 SG KIT-RM
Page 1: ......