6
RoutIng the poweR haRneSS
Locate the main power harness and plug it into the matching “pig-tail” on the side
of the amp. If installing 2x REV 225-RM, run the second power harness at the same
time as this step. The balance of the main wire harness will pass under the inner
fairing where the main wire harness passes through on the brake side of the bike.
Loosen the tank console and run wires up and over the gas tank, but under the
tank console. There is a provision on the front of the tank console for wires to pass.
Secure the amplifier’s harness to the bike’s factory harness using zip ties. When
correctly installed, the power and ground wires are the right length to connect on
to the battery.
Stock harness and amplifier’s
harnesses passing from fairing
to just in front of tank (Arrow A).
Cable tying the Harnesses to the
main bike harness just in front of
the tank (Arrow B) allows the amp
harnesses to go up towards the tanks
chrome console easier and makes for
a Cleaner Install.
Note: although not necessary, you can run the harness along the backbone of the
bikes frame if you choose to remove and re-install the bikes fuel tank.
Attach the red wire to the positive (+) battery terminal and the black wire to the
negative (-) battery terminal. The factory battery wires are also re-installed at this
point. Turn the ignition of the bike to the “on” position and play the stereo at low
volume to verify the amplifier is working fine.
IMPoRTAnT: with all wires secured, turn the front wheel to
each extreme side making sure that any wires cannot bind or
impede the steering of the motorcycle. failure to do so can cause
an accident resulting in serious injury or death!
Now is a good time to “clean up” and secure any wiring inside your fairing using
supplied zip ties. For best possible FM reception,
Do not attach any of
the amplifiers wiring to any factory antenna wires.
Doing so will
hurt your radios ability to receive FM signals!
Please go to “final system adjustments” near the back of this manual
a
B
B
a
Summary of Contents for G4 SG KIT-RM
Page 1: ......