Step #4: Continue running the rear harness towards the back of the bike making
sure it goes UNDER the air line for the rear shocks. When installed cor-
rectly, the 8 pin white plug will sit on the brake side rear fender strut. If
not already installed, plug in the 8 wire “pigtail” that runs speaker wires
into your rear speaker pods. You will see 2 shorter pairs of wires and 2
longer pairs. With your rear speakers/grills removed, run the 2 shorter
pairs into the brake side speaker box. The longer 2 pairs will run across
the back fender and into the clutch side rear box, and when the install is
complete will be pretty well hidden by the passenger backrest.
STEP #6: WIRING THE REAR SPEAKERS
If the bike is an Ultra or RG Ultra (Radio fader works): You will see 2 factory rear
speaker wires with female ends. Plug them into the 2 wires on the rear harness
with the male ends noting they will only go on one way. The left over 2 wires as
part of the amps rear harness have female connectors on them, and will plug
directly to the rear speaker. Complete for both side and go to Step #7
If the bike is a Standard, EG Classic, Street Glide or Road Glide (Radio fader does
NOT work): The wires inside the rear box with the male connectors are not used,
Please leave them inside the rear speaker box. DO NOT CUT them, as they may
be required if you expand your system later on! The wires with the female connec-
tors on them will plug directly to the rear speakers.
Attach the red wire to the positive (+) battery terminal, and the black wire to the
negative (-) battery terminal. The factory battery wires are also re-installed at this
point. Turn the ignition of the bike to the “on” position and play the stereo at low
volume to verify the amplifier is working fine
IMPORTANT: With all wires secured, turn the front wheel to each
extreme side, making sure that any wires cannot bind or impede
the steering of the motorcycle. Failure to do so can cause an
accident resulting in serious injury or death!
On the side of the amp is the level switch marked -3, 0 and +3. Using a small flat
head screwdriver, you can turn the amp up or down to “balance” between the
speakers this amp is powering, and the rest of the speakers on this bike.
Last but not least—please go back to page 3 and read the “adjusting your system”
section. You just spent a bunch of time getting the amp in so please take a minute
and adjust your system so it works as well as we know it should!
19
SYSTEM UPGRADE #1
If you’re using NCA 70.2 to power front speakers, this system is an easy way to
add rear speakers to your bike if you’ve added a King Tour-Pak
®
. Hogtunes rear
speaker pods come with a wire harness set-up for quick detach tour paks that will
plug right into the expansion port on the amp. Imprtant: Since the RADIO power
will be used to power the rear speakers, you must use rear speakers specific to
your year of bike!!
20
Use expansion port to send
radio’s built in power to a
second set of speakers
(rears on Non-Ultra Models)
Optional
HF-1/HF-2RG
Tweeter Pod
